Step 3: Install Water Storage Tank
1. On the nipple on top of the tank, apply Teflon
®
tape 4 or 5 times clockwise around in
the same direction as the threads.
2. Hand tighten the tank connector onto the tank nipple until secure.
NOTE: Do not cross thread or over tighten.
3. Using mount stand, place tank near the system
manifold. Measure 3/8" white tubing to the outlet side
of the system manifold and ensure you have enough
tubing to connect tank and system manifold as well as
enough left to attach faucet stem and remineralizer.
Cut 3/8" white tubing.
4. Install the 3/8" white tubing to the tank:
A. Push the tubing through the nut, collar and
sleeve into the connector.
B. Unscrew the compression nut from the tank
connector to ensure that the tubing is connected
all the way through the collar and sleeve.
C. Slide the nut to the threads and tighten with a
wrench. Avoid over tightening.
3. Drill two pilot holes for mounting
brackets using 1/8" drill bit for the
system manifold.
NOTE: Use caution
not to drill into anything beyond the
cabinet wall.
4. Insert mounting screws into the wall
leaving approximately 3/8" of each
screw exposed.
5. Remove first and third filter sumps
from manifold by turning each sump to the left and pulling down before hanging mani-
fold on wall. Mount manifold on wall and screw in. Be careful not to over tighten.
6. Screw in remineralizer holder onto wall.
OptimH2O™
OptimH2O™
OptimH2O™
