Installation Instructions
3
Attach white tube to the brass tee: Slide the compression nut
onto the white tubing (with threads of the nut facing the end of
the white tube). Next, slide the plastic sleeve onto the white tube.
Place brass insert into the opening of white tube. Push the tip of
the white tubing into the opening of the brass tee. While holding the
white tube in place inside the brass tee, tighten the compression
nut to compress the plastic sleeve and create a seal.
NOTE: Use a
wrench to ensure complete seal. Avoid over tightening.
4
Faucet Installation:
Install as shown.
Tighten nut to secure faucet to sink.
5
Faucet Connection:
Connect the
outlet hose to the base of the faucet by
sliding the chrome nut onto the tube
followed by the white collar. Place the
white insert into the end of the tube.
Press the tube against the faucet base
and slide the nut and collar up to the
threads. Use wrench to ensure seal is
sufficiently tight.
Note:
Avoid over-tightening.
1
Unpack and unwrap contents.
Turn off and disconnect the cold
water supply.
2
Attach threaded ends of supplied
brass tee to the cold water supply line
and shut-off valve; tighten using an
adjustable wrench.
P
E
H
F
G
L
J
K
