Refer to FAQ for benefits of additional
channels
Standard Wireless
Remote Functions
Single Shot Mode
Ensure camera is in single shot mode.
Refer to camera manual.
Using the 4-way joypad, put Transmitter
into Single Shot Mode.
To autofocus Ensure camera has
autofocus enabled.
Half press the transmitter button.
G
reen
light on transmitter and receiver indicates
autofocus is activated.
To release the shutter full press on the
Transmitter button. Red light on
transmitter and receiver indicates a single
shot has been taken.
Continuous Shooting Mode
Ensure camera is in continuous shooting
mode.
Put transmitter into continuous shooting
mode.
Half press the transmitter button to
autofocus.
Full press and HOLD transmitter button.
Camera shoots continuously for as long
as transmitter button is held down.
Bulb Mode - Long Exposures
Ensure camera is in Bulb mode.
Put transmitter into Bulb Mode.
Half press the transmitter button to
autofocus.
Full press the transmitter button to open
the shutter. Display starts counting the
period of time the shutter is open. Press
transmitter button again to close the
shutter and stop the display.
Basic Timer Modes
To set a specific number of shots and to
set a specific timed delay before taking
the first shot.
Ensure camera is in single shot mode.
Set the transmitter to Basic Timer Mode.
Press centre button. Use 4-way joypad to
select the number of shots, then the time
delay to first shot. Press centre button to
confirm and save setting.
Half press the transmitter button.
Full press Transmitter button.
Camera will autofocus between each
shot. Refer to FAQ to turn autofocus off.
Interval Timer
Programmable Functions
To programme the
G
iga T Pro II interval
timer, you must set the values for the
“Basic Programme” by inputting the
values into each of the Delay, Long,
Interval 1, N1 parameters.
To set the repeats of the “Basic
Programme”, set the values for frequency
and interval using the Interval 2 and N2
parameters.
Camera settings affect each of these
functions. For series of
Timed single shots, ensure camera is in
Single Shot mode.
Continuous shooting bursts, ensure
camera is in Continuous Shooting mode.
Long expsoures, ensure camera is in
Continuous Bulb mode.
Delay:
Time in hours, minutes and
seconds before whole
interval shooting
programme starts.
Use 4-way joypad to set the desired time
13
DELAY LONG INTVL 1 N1 INTVL 2 N2
13
14
15
16
17
18
C
Time delay
to first shot
in seconds
Number of shots
23
24
25
26
B
9
