Document Number: 69I00-1
69A00-1
Installation Instructions
Description:
The 69A00-1 4-Button Keypad is used to send up to 10 different wireless signals to the HAI 45A00-1 Wireless
Receiver to activate automation programs in the HAI controller. Each button, or combination of buttons, can
activate lighting, arm and disarm the security system, operate a garage door, set off a panic alarm, and many
other functions.
Operation:
When you press a button on the Keypad, a transmission will be sent after a 3/10 second delay. If desired, you
can program the buttons to have a variety of delays to help avoid accidental transmission. When the signal is
transmitted, the LED will light for conformation that the transmission was sent.
Note:
Button 4 is factory programmed to have a 2 second delay. You must press and hold Button 4 for 2
seconds before it will transmit.
You can also virtually eliminate false panic alarms by configuring the panic alarm to only activate when two
buttons are pressed simultaneously. This configuration is perfect for Police or Duress panic alarms. It helps
reduce false alarms by insuring a signal is sent only if two buttons are pressed simultaneously.
