59
To enter a voice description, enter the one, two, or three digit code shown in Table 2 in the Appendix C for each description
(word or group of words), then press the ' # ' key. After you have entered the complete description for each item (unit, zone,
button, code, temperature, and message), press the ' # ' key twice. You may enter up to four descriptions (word or group of
words) for each unit, zone, button, and code.
UNIT 1 VOICE:
↓
UNIT 1 VOICE:
144 109
↓
When Unit 1 is spoken over the phone, the Aegis 1000 will say, "UNIT 1 - PORCH LIGHT".
Set Up Address
The final setup item is accomplished over the telephone. This is the address that the system says when it dials out in an
emergency. Your voice will be recorded on computer chips in the Aegis 1000 controller and saved to be played back in the
emergency message when the system dials out for an alarm.
Pick up an inside phone and press the ' # ' key on the telephone within 3 seconds of picking up the phone. The Aegis 1000 will
respond with a menu. Press 8 on the telephone keypad, then 8. The unit will say "ADDRESS IS:" then the Aegis 1000 will play
back the message stored in the Address memory if one has been entered by your installer.
To record your address, Press 9, then enter the Master Code. The Aegis 1000 will say "RECORD ADDRESS", then BEEP. In a
normal tone of voice, say your name and address and any helpful information for locating your house.
"THE JONES RESIDENCE, 1234 JOHNSON STREET, CORNER OF JOHNSON AND THIRD STREET"
The unit will beep after 8 seconds, then play the address back to you. If you are not happy with the sound, re-record by pressing 9
and the Master Code. If you would like to hear the address again, press 8 for Play Address.
If you accidentally press 9 but have not entered your master code and do not wish to record a new address, simply hang up the
phone. The address can be recorded from a local (in house) phone or a remote phone. We suggest using a local phone for higher
sound quality.
Ø
When the Aegis 1000 says "record address - beep" any previous address recorded on your system is erased. Always
verify that you have your name and address in your system if you have entered this function.
Ø
When recording the address, do not press any touch-tone keys on your phone until the second beep, indicating that
recording is complete. This will cause improper operation when the system dials out. The Aegis 1000 will think that the
tone is a code being entered by the called party and it will stop talking.
