Page 4
Install the Lumina Keypad
1.
8 Lumina Keypads (Models 33A00-19 and 33A00-20) MAXIMUM per system, subject to power availability.
2.
Use 4-conductor 22-gage wire, 1000 feet maximum length. Keypads can be homerun or daisy chained. This length shall be
divided by the total number of keypads at the end of the run. For example, for 8 keypads, the maximum length reduces to
125 feet. All LCD Keypads are connected to the same 4 wires, +12, GND, A, B.
3.
The keypad should be mounted so that the LCD display is at or slightly above eye level. Keypads should be kept out of the
reach of young children. A good height is approximately 58 inches from the floor to the bottom of the keypad enclosure.
4.
Remove keypad face from back plate (slots on bottom of keypad will release back plate, use a screwdriver). Mount the back
plate to the wall. Mounting holes are designed to fit on a single or double gang box, or directly to the wall. Pull the wires
from the wall through the opening in the back plate. Splice the wires to the supplied cable. Connect the cable to the
connector on the keypad board (J1). Snap the keypad face on to the back plate. Remove protective film from the LCD lens.
(MOUNTED TO KEYPAD FACE)
KEYPAD PC BOARD
BACK PLATE
GREEN
YELL
O
W O
R
WHIT
E
BL
A
C
K
RE
D
YELLOW OR WHITE
GREEN
RED
BLACK
J1
SUPPLIED CABLE
(PLUGS INTO J1)
FROM CONTROLLER
ENDS OF 4 - WIRE CABLE
CABLE TO CORRESPONDING
CONNECT ENDS OF SUPPLIED
Summary of Contents for lumina
Page 2: ...Copyright 2001 2006 Home Automation Inc All Rights Reserved...
Page 114: ......
Page 115: ......
Page 116: ...HAI New Orleans LA U S A...