Page 5
Keypad Setup
The keypad has different operating options that can be setup from the keypad to the user's preference. If more than one keypad is
being used, it is required that you give each keypad a different address. You can change the address of a keypad through the
keypad setup mode.
To enter the keypad setup mode, simultaneously press and hold the 4 and up arrow (
×
) for approximately 1 second. The keypad
will beep 5 times and enter the setup mode. The top line of the display will indicate what you are doing, followed by the current
setting. The bottom line will show a menu of your options. To the lower right corner of the display is the direction arrow(s).
Where possible, the up (
↑
), down (
↓
), and two-headed ( ) arrow characters are shown on the keypad display to indicate which
arrow keys may be pressed at that time. Press the down arrow (
Ø
) key to advance to the next item. Press the up arrow (
×
) key to
go back to the previous item.
Console Address
If you are installing more than one keypad, each keypad must be set to a different address. The default address setting is (1) - this
is adequate if only one keypad is being used. The choices at the bottom are 1-16. When making your choice, choose an address
between 1-8, and then press the # (pound) key.
Sounder
If you wish not to hear the beeper in the keypad for any reason, the sounder option can be turned off. Select (0) for OFF or (1) for
ON, then press the # key.
Key Click
The sounder makes a click every time a key is pressed. This option may also be turned off. Select (0) for OFF or (1) for ON,
then press the # key.
Key Backlight
The keys on the keypad are lit. The keys can be never lit, always lit, or only lit when the LCD display is lit. Select (0) OFF, (1)
for ON, or (2) TIMED, then press the # key.
Viewing Adjustment
This option is an adjustment for the viewing angle of the LCD display. This has been set to its best value at the factory, however,
you may wish to tweak it. The display has 20 levels of adjustment. Select (1) for a lower viewing angle, or (2) for a higher
viewing angle.
Language
This option is to display the 'keypad setup' text on the LCD display in English, French, Italian, or Spanish. Select one of the
languages, then press the # key.
Exit Setup Mode
To exit Setup Mode, press and hold the 4 and up arrow (
×
) keys simultaneously for about 1 second. The keypad will return to
normal operation. You may need to press (*) to restore the display.
Summary of Contents for lumina
Page 2: ...Copyright 2001 2006 Home Automation Inc All Rights Reserved...
Page 114: ......
Page 115: ......
Page 116: ...HAI New Orleans LA U S A...