Page 13
Keypad Check Out
1.
The keypad(s) should be operating. Press '
*
' to silence the trouble beeper if it is beeping. If the keypads are not operating
properly, make sure that no two keypads have the same address, and check the wiring.
2.
The bottom line of the display should read SYSTEM OK. If there are any trouble indications that occurred during
installation, press '
* ' to acknowledge them and silence the beeper.
3.
Set the time and date by pressing the 9 key. Enter the Master Code, and then press the 2 key. Enter the time on the keypad.
If Daylight Savings Time is currently being observed (between spring and fall), set this item to "Yes". If Daylight Savings
Time is not currently being observed (between fall and spring) or is not observed in your geographic location, set this item to
"No". This item is used to correctly calculate the times for sunrise and sunset. Once the time is set, the Lumina controller
will automatically adjust the "time of day" each time daylight savings time begins and ends.
Next you are prompted to enter the date. If the current date is February 8, 2006, enter it as “0 2 0 8 0 6”.
4.
The keypad should now show the time and date on the top line and "SYSTEM OK" on the bottom line.
Telephone Check Out
1.
Verify that the Telephone Company surge arrestor is properly grounded.
2.
Verify that the incoming telephone lines are run to the surge arrestor first, then from the surge arrestor to the RJ31X jack,
then from the RJ31X jack to the house phones.
3.
The PHONE LED, on the controller, should be off when the phones are hung up.
4.
Pick up an in-house phone, wait about 1 second, and then press the ' # ' key. You should hear the voice menu on the phone.
If not, check to see that the RJ31X jack is properly wired and connected to the controller. There should be no interference
from the Telephone Company while the menu is being read over the phone.
5.
Record the owner's NAME and ADDRESS in the address speech memory as shown in Setup Address (Press 8, 9, then 1111
or the current Master code to record the address) –
See
Set Up Address
.
NOTE: DO NOT record any TOUCH TONES in the ADDRESS!!
6.
Check that all in-house phones are working.
In Case of Trouble
Keypads
If you experience trouble that seems to be with a keypad, try disconnecting the keypad and running the keypad self test. If the
keypad does not run the self-test properly, it should be returned to HAI for repair.
"NO CONTROLLER DATA" or erratic operation of the LCD display could be a result of: A and B terminals connected
backwards, poorly, or 2 or more keypads have the same address.
Controller
Check the AC ON (bottom) LED. If it is not lit, check for 24 VAC at the transformer connections.
Check the STATUS (middle) LED on the controller board. It should be blinking once per second, indicating the proper operation
of the microprocessor and memory. If not, try powering the system down by disconnect the power transformer and battery, then
reconnect both. The status light should begin blinking.
Summary of Contents for lumina
Page 2: ...Copyright 2001 2006 Home Automation Inc All Rights Reserved...
Page 114: ......
Page 115: ......
Page 116: ...HAI New Orleans LA U S A...
