Page 43
HLC House Controllers
To configure the HAI UPB™ 8-Button House Controller, put the device in Setup mode as follows:
Step Operation
1
Press and hold the “1” and “8” pushbuttons simultaneously for at least 3 seconds.
2
All of the LED indicators will blink to indicate that the HAI UPB™ 8-Button House Controller is in Setup Mode.
Note:
The HAI 8-Button House Controller will automatically exit Setup mode after 5 minutes. To manually exit Setup
mode, press and hold the “1” and “8” pushbuttons simultaneously for at least 3 seconds.
Note:
When Lumina finishes configuring the device, it will automatically exit Setup mode and return to normal operation.
Lumina Mode Controllers
To configure the HAI UPB™ Lumina Mode Controller, put the device in Setup mode as follows:
Step Operation
1
Press and hold the “AWAY” and “HOME” pushbuttons simultaneously for at least 3 seconds.
2
All of the LED indicators will blink to indicate that the HAI UPB™ Lumina Mode Controller is in Setup Mode.
Note:
The HAI Lumina Mode Controller will automatically exit Setup mode after 5 minutes. To manually exit Setup
mode, press and hold the “ON” and “OFF” pushbuttons simultaneously for at least 3 seconds.
Zone Status
The Zone Status menu allows you to view and scroll through the status of each zone input. To enter the Zone menu, from the
Status menu, press the 2 (ZONE) key on the numeric keypad. The system will display:
Front Door SECURE
ZONE 1
↓
You may enter a zone number, or simply press the down arrow key to start with the first zone. The arrow keys may be used to
continue scrolling between zones. For each zone, the display will show the zone name, the zone number, and the current state of
the zone.
Sunrise / Sunset Status
The system automatically calculates the time of sunrise and sunset each day. From the status menu, press the 3 (SUN) key on the
numeric keypad to display the calculated time of sunrise, sunset, and the outdoor temperature (if outdoor temp sensor installed):
Sunrise: 6:00 AM Temp
Sunset: 5:58 PM 85
Test Status
The diagnostic test performed by the Lumina allows you to check the status of the battery, telephone, bell circuit, auxiliary fuse,
and zone loop readings. The display is updated 3 times per second, although the actual readings are taken 10 times per second.
To enter the Test menu, from the Status menu, press the 4 (TEST) key on the numeric keypad.
The first display shows the current battery reading and the phone line status. A battery test is initiated when the status mode is
first entered. The new battery reading is updated ten seconds later. The low battery limit is also displayed.
The phone status consists of two parts, separated by a "/". The first part shows the current phone line state:
ONHK
- ON HOOK
OFFHK
- OFF HOOK
RING
- RINGING
DEAD
- DEAD PHONE LINE
Summary of Contents for lumina
Page 2: ...Copyright 2001 2006 Home Automation Inc All Rights Reserved...
Page 114: ......
Page 115: ......
Page 116: ...HAI New Orleans LA U S A...
