Page 80
Set Up Names
The system can be set up to display descriptive names such as "FRONT DOOR", "JOHN'S BEDROOM", or "PORCH LIGHT"
for zones, units, buttons, codes, temperatures, and messages. These names are displayed instead of the unit, zone, button, code,
temperature, and message number that is normally displayed. Zone and Message names may be up to 15 characters long. Each of
the other names may be up to 12 characters long.
To enter the
Set Up Names
menu, from the Setup menu, press the 7 (NAME) key.
SET
UP
NAME
1=CTRL 2=ZONE 3=BTTN
↓
4=CODE 5=TEMP 8=MSG
↑
Select the item that you would like to name by pressing one of the keys (1-5, or 8). The current name or number for the first item
(unit, zone, button, code, temperature, and message) is then displayed.
There are two ways to enter a name for units, zones, buttons, and temperatures:
1)
Lumina has a list of predefined names that you to select from (Quick-Set Names)
2)
You can enter the two-digit code shown in Appendix C for each character in the name
Note:
To assign names to codes and messages, you must use the two-digit codes as shown in Appendix C.
Using Quick-Set Names
For example, press 1 to name units:
UNIT 1:
00-95 #=LIST
↓
Press the ' # ' key to display a list of names that are stored in the controller. Each name in the list is displayed on the bottom line
of the display.
UNIT 1:
Basement
↓
When using the list of names, the following should be observed:
¾
The first item in the list is blank. This is used to delete an existing name for the respective Unit Number.
¾
The list is in alphabetical order.
¾
If the Unit Number is the 1st unit in a Room (i.e. Unit 1, 9, 17, 25, etc.), the list will start with Room names.
¾
In the Unit Number is between the 2
nd
and 8
th
unit in a Room, the list will start with Lighting Load names.
Use the up arrow (
↑
) and down arrow (
↓
) keys to scroll through the list of available names for the device. When appropriate
name appears, press the ' # ' key to select that name for the device. The name now appears next to the item designation:
UNIT 1: Living Room
00-95 #=LIST
↓
Once the name is selected for the specified item, press the down arrow key to name the next item.
Using the Two-Digit Character Codes
When naming the device using the two-digit codes shown in Appendix C, enter the two-digit code for each character in the name.
Use the up arrow key to delete the most recently entered character.
ZONE 1: FRONT DOOR------
00-95
↑
=DEL
Once complete, press the ' # ' key to save the name.
Summary of Contents for lumina
Page 2: ...Copyright 2001 2006 Home Automation Inc All Rights Reserved...
Page 114: ......
Page 115: ......
Page 116: ...HAI New Orleans LA U S A...
