Page 74
The default for
Dial Out 1 On
is 12:00 AM MTWTFSS, and the default for
Dial Out 1 Off
is Never, so that
Dial Out Number 1
is
always active.
The Time that was entered before setting an On or Off time to Never is saved, and will be redisplayed when a day is set in place
of Never. Setting both the
Dial Out 1 On
and the
Dial Out 1 OFF
times to Never will make Dial Out Number 1 never active.
Dial Out Numbers 2-8
The default Dial Out On and Off times are the same as
Dial Out Number 1
.
Dial Order
The dial order is the order in which call all will be placed if an Alarm is activated.
You can have the system make up to 8 calls in the event of an alarm. You may chose from
Dial Out Numbers 1 - 8
. You can
have the system dial a number twice (or more) which is suggested if you don't have a direct dial number at work, so that your
company operator can find you, if you aren't at your desk, and have you alerted for the next call.
Up to eight numbers may be entered. Enter the
Dial Out Order
by pressing the keypad digits 1, 2, 3, 4, 5, 6, 7, or 8 for
Dial Out
Numbers 1, 2, 3, 4, 5, 6, 7, or 8
, respectively. When you have entered the dial order of your choice, press ' # '. Enter a single ' 0 '
if no dial out is desired. The default
Dial Order
is 1 2 3 4 5 6 7 8.
Set Up Arming
To configure different arming and disarming options, from the Setup menu, press the 5 (ARM) key.
Entry Delay
The
Entry Delay
is the time, in seconds, that you have to disarm the alarm system after entering your home. The
Entry Delay
only
applies to the entry/exit zone (e.g. your entry doors). If you (or someone else) come in through a window, there will be no
entry delay and the alarm will sound immediately.
When you come in through a door on an entry/exit zone, the other zones are delayed too. This allows you to get to your phone or
console to turn off the security system, even if you have to go through a room protected by a motion detector.
Some doors (a back door or garage door) may be configured as a
Double or Quadruple Entry Delay
. If so, that door has two
times or four times the entry delay shown on the display.
ENTRY DELAY: 30
30-60 SECONDS
↓
The default
Entry Delay
is 30 seconds. You may change it from 30 to 60 seconds.
Exit Delay
The
Exit Delay
is the time, in seconds, that you have to leave your house when you turn on the system. When arming the system
in Day, Night, Away, or Vacation modes, the system will wait this amount of time before arming.
EXIT DELAY: 60
45-180 SECONDS
The default
Exit Delay
is 60 seconds. You may change it from 45 to 180 seconds.
Exit Time Restart
When
Exit Time Restart
is set to Yes, the Exit Delay will restart if the same exit zone is violated twice within the original exit
delay. For example, after arming the system if you open the front door to leave, close the front door behind you, and then reenter
through the front door while the exit delay is still in effect, the exit delay will be restarted. This is designed to give you additional
time to exit without causing an alarm. The exit time will only be restarted once within a given arming period.
Summary of Contents for OMNI IIe
Page 2: ...Copyright 2001 2009 Home Automation Inc All Rights Reserved ...
Page 116: ......
Page 117: ......
