Page 59
Access Areas
After an authority level has been entered, you will be prompted for access areas for the user. Specify which area(s) (if part of
your system) the user has access to by pressing the number for each area.
The display will show all areas that have been enabled for that user. After the area(s) is/are selected, press the ' # ' key.
CODE 2 AREAS:
1 2 0=CLR
You can specify the access (on/off) times for the code; this is, the time periods during which the code is valid.
CODE
2
ON
TIME:
8:00 AM MTWTF-- #=CHNG
CODE
2
OFF
TIME
5:00 PM MTWTF-- #=CHNG
The times and days are changed by pressing the ' # ' key. Choose the 1 (TIME) key to change the On or Off times. You will be
prompted to enter the new time. AM/PM must be specified for the time if the AM/PM format is being used, otherwise the entered
time should be 13:00-23:59. Each item defaults to its current value. Press the up arrow key to select Sunrise and press the down
arrow key to select Sunset.
CODE 2(ON/OFF)TIME:
1=TIME
2=DAYS
TIME: 8:00 AM
HHMM
↑
=RISE/AM
↓
=SET/PM
To change days, press the ' # ' key, then press the 2 (DAYS) key. You will be prompted to enter the day(s) that the code will be
valid. Press 1-7 for Monday - Sunday, 0 for Never, 8 for Weekdays, and 9 for Weekends.
DAY(S):
MTWTFSS
1-7=MON-SUN
0=NEVER
Duress Code
If you are forced to disarm the system against your will by an intruder, disarm it as you normally would, but use the Duress Code
instead of your normal code. The system will disarm normally. No sirens will sound, no lights will flash, but the OmniPro II will
perform a silent dial out and say that this is a silent alarm.
To stop a silent dial out, turn your security system off by pressing OFF, then your code.
DURESS CODE:
0000-9999
0000=DISABLE
↑
Set Up Time
To set up time and date, from the Setup menu, press the 2 (TIME) key.
TIME:
HHMM
↑
=AM
↓
=PM
You will be prompted to enter the new time and date. AM/PM must be specified for the time if that format is being used,
otherwise the entered time should be 13:00-23:59.
Next, you are then prompted with a question that asks if Daylight Savings Time is currently being observed:
DAYLIGHT
SAVINGS
TIME?
0=NO
1=YES
Summary of Contents for Omni Pro II
Page 2: ...Copyright 2001 2007 Home Automation Inc All Rights Reserved...
Page 107: ......
