Page 72
Program Message Commands
Select the 8 (MESSAGE) key to show, log, clear, say, phone, or send a message. Specify the desired command -
See
Message.
MESSAGE
1=SHOW 2=LOG 3=CLEAR
↓
4=SAY 5=PHONE 6=SEND
↑
The 1 (SHOW) key allows you to display the selected text message(s) on the console's top-level display. This can be a helpful
reminder of special events and occasions.
The 2 (LOG) key allows you to store the selected text message(s) in the Event Log. This can be a helpful to keep track of the
times and dates of events and occurrences.
The 3 (CLEAR) key allows you to clear the selected text message, or all text messages from the console's display.
The 4 (SAY) key allows the controller to say the selected voice message over a speaker. This voice message can be an audible
reminder of special events and occasions (i.e. "Front Door Open" when the front door is opened).
The 5 (PHONE) key allows the controller to call the selected phone number and say the selected voice message.
The 4 (SEND) key allows you to send any a text messages through the Pro-Link serial port.
Display Message without Beeping / Without Beeping or Flashing the LED
Using HAI PC Access Software, when creating programs to display a message on a console or touchscreen, you can specify if the
message will be displayed “With Beep” (the console will beep 5 times), “No Beep” (the console will not beep, but the LED will
flash), or “No Beep or LED” (the message will be displayed on the console but the console will not beep or flash the LED).
When a message is displayed and “No Beep” is selected, the LED on the console will continue to flash until you acknowledge it
by pressing “*” key. Furthermore, on a touchscreen, the message will be displayed in the center of the screen until you
acknowledge it by pressing the “OK” button.
When a message is displayed and “No Beep or LED” is selected, the message will simply be displayed on the status line of the
console or touchscreen; no audible or visual indication is given.
SUNSET M--T---: SHOW TRASH NIGHT NO BEEP OR LED
Beep Command
Using HAI PC Access Software, you can create programs to beep a console (or touchscreen) or all consoles (or touchscreens).
You can program the console(s) to beep once per second indefinitely, to turn off a previous “beeper on” command, or a single
beep 1-5 times.
WHEN POOL DOOR NOT READY: ALL CONSOLES BEEP 5
Enable or Disable Beeper Programmatically
Using HAI PC Access Software, you can create programs to either enable or disable the console or touchscreen beeper;
individually or all devices. When the beeper is disabled, no audible beeps are emitted from the device, except for alarm
conditions. All other beeps (i.e. entry and perimeter chimes, audible exit delay, entry pre-alarm, error beeps, confirmation beeps,
trouble beeps, etc.) will not be emitted from the respective console or touchscreen.
This may be used to disable the beeper in a bedroom at night.
WHEN NIGHT: CONSOLE 5 DISABLE BEEPS
WHEN OFF: CONSOLE 5 ENABLE BEEPS
Summary of Contents for Omni Pro II
Page 2: ...Copyright 2001 2007 Home Automation Inc All Rights Reserved...
Page 107: ......
