Page 75
Set Up Dial
The
Set Up Dial
menu is used to configure all of the telephone related items for the OmniPro II. To enter the
Set Up Dial
menu,
from the Setup menu, press the 4 (DIAL) key. Use the arrows to scroll through the items. For each item, the top line displays a
description of the item and its current setting. The bottom line shows the available ranges for your selections.
Phone numbers can be up to 24 characters long. The number is shown on the bottom line of the display. Press the OFF key to
enter a ' - ' into the number. Press the DAY key to specify a pause of 2 seconds (shown as a "T" on the display). Press the
NIGHT key to enter a ' # ' into the number. Enter a single ' - ' for no number.
Telephone Access
The
Telephone Access
item allows you to turn the local (in-house) and remote telephone control feature on and off.
If set to On, the OmniPro II will allow local and remote telephone access as described in Telephone Control. If set to Off, the
OmniPro II will not answer incoming calls ever, and will not work on the in house phones. Dial outs will still occur, and the
system will operate normally when the OmniPro II dials out.
If you do not have your OmniPro II connected to a phone line, set
Telephone Access
to Off to keep the system from displaying
"PHONE LINE DEAD". The default setting for
Telephone Access
is On.
Answer Outside Call
If you do not want your system to
Answer Outside Call
, set this item to No. The local (in-house) telephone control features will
still work, but the system will never answer an incoming call.
The default setting for
Answer Outside Call
is Yes.
Remote Commands
The
Remote Commands Ok
item allows you to prevent any commands from being issued from a remote telephone.
If
Remote Commands Ok
is set to Yes, the OmniPro II will allow all commands to be executed when called from a remote
telephone. If
Remote Commands Ok
is set to No, then lights, appliances, and the security system cannot be controlled from a
remote telephone that dials into your home.
You can issue commands from a local (in-house) phone with
Remote Commands Ok
set to Yes or No. The default setting is Yes.
Rings Before Answer
Your phone must ring this number of times before the OmniPro II will answer an incoming call to your phone.
To change
Rings Before Answer
, enter the new number from 1 to 15, then press the ' # ' key. The factory default setting is 8.
Dial Type
The
Dial Type
specifies the type of dialing used when the OmniPro II dials out. If you do not have Touch-Tone service, then
Dial
Type
must be set to Pulse.
The default
Dial Type
is Tone.
My Phone Number
My Phone Number
is the phone number that will be announced when the OmniPro II dials out in the event of an alarm. It should
be set to the phone number of the premises where your system is installed.
To enter phone numbers, press the keypad keys 0 - 9. You can put in a dash (-) for legibility by pressing the Off key.
Press the ' # ' key after you have pressed all of the digits in the phone number. For example, to enter the number 555-1234, press
555 "OFF" 1234 #.
Summary of Contents for Omni Pro II
Page 2: ...Copyright 2001 2007 Home Automation Inc All Rights Reserved...
Page 107: ......
