Page 12
LANGUAGE
This option is to display the 'console setup' text on the LCD display in English, French, Italian, or Spanish. Select one of the
languages, then press the # key.
EXIT SETUP MODE
To exit Setup Mode, press and hold the 4 and up arrow (
!
) keys simultaneously for about 1 second. The console will return to
normal operation. You may need to press (*) to restore the display.
CONSOLE SELF TEST
Use the self test mode to verify the proper operation of the console.
1.
Disconnect the console from the controller. C12 and GND terminals to a 12-volt source (or a fresh 9-volt transistor
battery.) The console beeper will beep twice per second, the LCD backlight and the keypad key will be lit, and the LCD will
display "NO CONTROLLER DATA".
2.
Simultaneously press and hold the 7 and the down arrow (
"
) keys for approximately 3 seconds. The beeper will beep 5
times, the LCD backlight and keypad backlight will turn off, and the display will clear. The LED at the top right corner of
the console will start to cycle through its different colors (red, green, yellow, then turns off). At the end of each cycle the
beeper will beep once.
3.
Press any key. The LCD backlight and the keypad key backlight will turn on.
4.
Press the keys in the following order and verify that the appropriate character fills the screen. 0 - 9, *, #, AWAY (A),
NIGHT (B), DAY (C), OFF (D),
!
(filled blocks), and
"
(blanks).
5.
If this is successful, the console is good. Simultaneously press and hold the 7 and down arrow (
"
) keys to exit the self test
mode or disconnect power.
Summary of Contents for Omni Pro II
Page 2: ......
Page 21: ...Page 15 BLACK RED RED FIGURE 7 SOUNDER CONNECTIONS...
Page 71: ......
Page 72: ...HAI New Orleans LA U S A...
