Page 36
TEMPERATURE
The general-purpose TEMPERATURE ZONE type is typically used to monitor indoor temperatures and control devices. It sets
the zone secure/not ready for program conditionals and event button activation.
If FREEZE ALARM is enabled, it reports a potential freeze condition if the temperature falls below 40
o
.
TEMPERATURE ALARM
The TEMPERATURE ALARM ZONE type will generate an alarm (console beeper, no sirens) and dial out if the temperature
goes above the high setpoint or drops below the low setpoint.
NOTE ON TEMPERATURE ZONE TYPES
Outdoor temperature, temperature, and temperature alarm zone types all have HEAT and COOL setpoints. The zone is "not
ready" if the temperature is above the high setpoint OR below the low setpoint. The zone is "secure" if the temperature is
between the setpoints. Setting a setpoint to 0 disables the setpoint.
Except for a type 83, the alarm is not activated. The zone "not ready" or "secure" status is used to activate button programs and
program conditionals.
SETUP DIGITAL COMMUNICATOR
To setup the Digital Communicator, from the Installer Setup menu, select the 3 (DCM) key.
FIRST PHONE NUMBER, FIRST ACCOUNT NUMBER
The first item in the DIGITAL COMMUNICATOR category is the FIRST PHONE NUMBER. Enter the FIRST PHONE
NUMBER on the keypad. This enables the Digital Communicator. You can cause a 2-second pause during dialing by pressing
the DAY key. Press ' # ' when done.
FIRST PHONE NUMBER:
-
↓
To disable the digital communicator, enter a single "-" for the FIRST and SECOND PHONE NUMBER by pressing the OFF key,
then ' # '. Phone number may be up to 24 digits long.
Press the down arrow (
"
) to advance to the FIRST ACCT NUMBER:
FIRST ACCT NUMBER: 0000
0-FFFF
↕
Enter the 4 digit account number (3 digits if using 3/1 format) and press ' # '. To enter the digits B-F, first press the OFF key, then
press the 1-5 key respectively (i.e. 1B11 = 1 OFF 1 1 1 #).
NOTE: You must enter 4 digits for the account number if you are using Contact ID or a 4/2 format (i.e. 0123), and 3 digits
if using 3/1 (i.e. 123).
SECOND PHONE NUMBER, SECOND ACCOUNT NUMBER
Enter these if used.
SECOND PHONE NUMBER:
-
↕
SECOND ACCT NUMBER: 0000
0-9999
↕
