8
8
INSTALLER SETUP
This section describes the items that the installer must setup as part of the thermostat installation. The Installer
Setup mode is used to configure the general operating parameters of the thermostat.
When in Installer Setup mode:
1.
The small digits on the top of the display are the item number.
2.
The large blinking digits in the center of the display are the value of the item number.
3.
Press the Prog (
>
) key to advance to the next item.
4.
Press the Hold (
<
) key to return to the previous item.
5.
Use the arrow keys (
∧−∨
)
to change the value of each item.
6.
Do not set the values to anything other than the specified range for each item.
7.
To exit Setup mode, press the Fan key.
The thermostat will automatically exit Setup mode after 20 seconds of no key activity.
To enter the Installer Setup mode, press the Prog key three times (day will flash), then press the Fan key.
The word "default" indicates the initial setting when the thermostat is delivered from the factory.
