INSTALLER SETUP
This section describes the items that the installer must setup as part
of the thermostat installation. The Installer Setup mode is used to
configure the general operating parameters of the thermostat.
When in Installer Setup mode:
1. The small digits on the top of the display are the item number.
2. The large blinking digits in the center of the display are the value
of the item number.
3. Press the Prog (>) key to advance to the next item.
4. Press the Hold (<) key to return to the previous item.
5. Use the arrow keys (
∧
-
∨
) to change the value of each item.
6. Do not set the values to anything other than the specified range
for each item.
7. To exit Setup mode, press the Fan key.
The thermostat will automatically exit Setup mode after 20 seconds
of no key activity.
To enter the Installer Setup, set Mode to "OFF". After 10 seconds,
press the Prog key three times (day will flash), then press the Fan
key.
ITEM NUMBER
VALUE
10
