4
Turn the retaining flange screws clockwise until they are snug (do not over tighten).
WALL
Before installing faceplate, remove the protective film from the LCD area of the touchscreen.
Fasten the faceplate onto the touchscreen by hanging the top of the faceplate on the top edge of
the touchscreen, then gently snapping the bottom onto the touchscreen.
REMOVING THE TOUCHSCREEN
After installation, if it is necessary to remove the touchscreen from the wall, turn retaining
flange screws 1 turn counterclockwise.
Note: Do not turn the retaining flange screws more than 1 full turn counterclockwise; otherwise
the retaining flange may fall off into the wall.
Summary of Contents for OmniTouch 32A00-1
Page 12: ......
