9.3.2: One-Key Arming
You can arm the system by pressing any of the three arming keys on the keypad. If One-
Key Arming is enabled, the system does not prompt you for a user code.
To program the One-Key Arming setting:
1.
From the Programming menu, select System Options, Arm/Disarm, One-
Key Arming [94032].
2.
Select Enabled or Disabled.
9.3.3: Supervised Arm
The Supervised Arm option is a feature designed to supervise intrusion sensor activity
before you arm the system.
If the system has not received a transmission from a sensor during the interval defined
for this option, all arming methods that include that sensor shall not be available.
Medical, Panic, Fire, Gas, Flood and Environmental zones are not included in this
supervision and do not affect the system’s ability to arm.
Press
to check which sensor is causing the “System Not Ready” condition.
To make the required arming method available, activate the sensor. It is important to
remember that the PIR sensors have a four-minute delay between transmissions.
If activating the sensor does not help, there may be a problem with the sensor. You can
bypass the faulty sensor’s zone to allow system arming until the problem is remedied.
1
Zone bypassing is valid for one arming period only. All bypassed zones are automatically
unbypassed when the system is disarmed.
To program the Supervised Arm interval:
1.
From the Programming menu, select System Options, Arm/Disarm,
Superv. Arm [94033].
2.
Enter a Supervised Arm interval (001-255 minutes or 000 to disable
the Supervised Arm option).
3.
Press
3
when the desired setting is displayed.
1
Do not program a Supervised Arm interval that is less than the sensor’s supervision time.
9.3.4: Instant Arming
Instant arming is a feature that allows you to cancel the entry delay after arming the system
–
see 3.7.7: Instant Arming
. The feature is designed for use in situations where the system’s
perimeter is armed and nobody is expected to enter the premises from outside.
To enable/disable the Instant Arm option:
1.
From the Programming menu, select System Options, Arm/Disarm,
Instant Arming [94034].
2.
Select Enabled or Disabled.
9.3.5: Keyfob Disarm
The Keyfob Disarm option enables you to determine whether it is possible for the user to
disarm the system using their keyfob at all times or during the entry delay only.
1.
From the Programming menu, select System Options, Arm/Disarm,
KF Disarm [94035].
2.
Select Always or On Entry.
-58-
©
HAIBRAIN
Summary of Contents for PROGUARD 800 Series
