Haier 2U14CS1ERA Service Manual Download

Page: 45 / 116

Domestic air conditioner

2U14CS1ERA-SM

Introduction

Outdoor Unit

Loading of the battery

Parts and Functions

Indoor Unit

OUTLET

INLET

CONNECTING PIPING AND ELECTRICAL WIRING

DRAIN HOSE

Remote controller

Remove the battery cover;

Load the batteries as illustrated.

2 R-03 batteries, resetting key

(cylinder);

Be sure that the loading

is in line with th

e" + "/"-";

Load the battery,then put on the cover again.

The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.

When electronic-started type fluorescent lamp or change- over

wireless telephone is installed in the

ver is apt to be disturbed in receiving the signals,

so the distance to the indoor unit should be shorter.

type fluorescent lamp or
room, the recei

Note:

Full display or unclear display during operation indicates the

ries have been used up. Please change batteries.

If the remote controller can't run normally during operation, please

reload several minutes later.

batte

remove the batteries and

Please be subject to the actual produce purchased the

above picture is just from your reference

Hint:
Remove the batteries in case won't be in use for a long period. If
there is any display after taking-out, just press reset key.

Please be subject to the actual produce purchased the
above picture is just from your reference

Display board

(adjust left and

ow)

Vertical blade

r ight air fl

Air Purifying Filter

Inlet

(inside)

Emergency

Switch

Horizontal flap

(adjust up and down air flow
Don't adjust it manually)

Outlet

Inlet grille

Display board

Signal receiver hole

ON/OFF

display

TIMER ON\OFF display

SLEEP display

Ambient temp.display

When receiving the remote

control signal, display the set

displayed and this room

time the room temperature is

temperature and in the rest

temperature is only for reference.

Note to the power failure resume:

press the sleep button ten times in five seconds
and enter function after hearing four sounds.And
press the sleep button ten times within five
seconds and leave this function after hearing

TIMER ON-OFF display

COOL\HEAT\Dry\

AUTO

display

two sounds.

1. Mode display

2. Signal sending display

4. FAN SPEED display

5. LOCK display
6. TIMER OFF display

TIMER ON display

MED

7.TEMP display

16. LOCK button

Used to lock buttons and LCD display.

25. RESET button

When the remote controller
appears abnormal, use a sharp
pointed article to press this button
to reset the remote

22. HOUR button

Operation mode

AUTO

FAN

COOL

DRY

Remote controller

HEAT

Control the lightening and extinguishing
of the indoor LED display board.

3. SWING display

9. QUIET button
10. HEAT button
11. COOL button
12. AUTO button
13. FAN button
14. TIMER button
15. HEALTH button

17. LIGHT button

18. POWER ON/OFF button
19. DRY button
20. TEMP button
21. SWING button

23. EXTRA FUNCTION button

24.CANCEL/CONFIRM button

AUTO

Function: Setting and cancel to the
timer and other additional functions.

Display
circulated

Operation mode

Remote controller

QUITE

POWER

SLEEP

Supplemented
electrical
heating

HEALTH

Additional functions display

Healthy function is not available for some units.

Function: Air sending--- Healthy airflow
position1--- Healthy airflow position 2
--- Restore the original flap position
--- Right & left air airflow--- A-B yard---
10 and heating symbol displayed
simultaneously--- Sleeping--- Electrical
heating--- Refresh air(

reserved function

)

--- Power--- Fahrenheit/Celsius mode
conversion