Chapter 6: INSTALLATION AND ACCESSORY PARTS
6
5. If the extra hose is too long, cut it either
●
at point A or B.
B
A
> 30mm
<1.5m
1.The height of the drain hose shall be
less than 10cm , or the drainage will
not be smooth enough and cause
incomplete drainage.
2.Do not tramp or press the drain hose.
3.If the drain hose is too long, cut it at mid point.
To make smooth drainage, cut the front end of
the hose slantingly.
4.If extra drain hose is needed , please make
separate purchase. The inner diameter of the
extra hose shall not less than 30mm, and the
length shall not exceed 1.5m.
<10cm
Please install and adjust the machine according to the requirement of
the manual. It is very important to your security and correct operating
the machine.
Install the lint filter
Usage of the drain hose
6.1 Dismantle and installation
Figure 1
Service Manual
Model NO:LMD7023PBBP
Issue
Rev.
lint f ilte r
Place the bottom side of the lint filter into the
overflow filter, then push the top side into the
overflow filter.
After installation, please double check to
make sure that the lint filter is installed in the
correct location; otherwise it may fall off
during operation.
Edi
ted w
ith the trial version of
Foxit Advanced PDF Editor
T
o remove this notice, visit:
w
ww.foxitsoftware.com/shopping
All manuals and user guides at all-guides.com
