Haier A2FE635CFJRU, Service Manual

SERVICE MANUAL

Model: 

5

Issue 

Rev. 

1-2-5. Use the genewing parts (specified parts) 

Special parts which have purposes of fire retardant (resistors), high-quality sound (capacitors), low 
noise (resistors), etc. are used.When replacing any of components, be sure to use only 
manufacture's specified parts shown in the parts list. 

Safety Component 

●

 Components identified by 

  mark have special characteristics important for safety.

1-2-6. Safety Check after Repairmen 

Confirm that the screws, parts and wiring which were removed in ordertoservice are put in the original 
positions, or whether there are the portions which are deteriorated around the serviced places 
serviced or not. Check the insulation between the antenna terminal or external metal and the AC cord 
plug blades. And be sure the safety of that. 

Insuration Test 

1.  Check if there is any leak of current. 

2.  Cut out the power supply before the repair to avoid an electrical shock hazard. 

3. In the case of a live-line test, insulating gloves should be worn to avoid potential electrical 

shock. 

4.  Confirm the rated current, voltage and capacity before testing with any kinds of instruments. 

5.  Watch if the upper door is open when you check something at a lower position. 

6.  Take out every part in the cabinet before moving the machine, especially things like panels 

(e.g. glass shelf). 

7.  Please wear intact cotton gloves when repair any parts of the evaporator, so that scratches 

by the sharp fins can be avoided. 

8. 

If there is a breakdown with the refrigeration system, please surrender the machine to 

the service center, else the leaked refrigerant may pollute the atmosphere

. 

9.  The refrigerator use AC of 220~240V with a frequency of 50Hz. 

10. A big fluctuation of voltage (exceed the range 220

～

240V) may cause a start failure of the 

refrigerator, a burn-out of the control panel and compressor, or an abnormal sound from the 

compressor in operation. In this condition an automatic voltage regulator over 750W should be added. 

11. Take care not to damage the supply line. Don’t yank at the line; pull the plug out gently from 

the receptacle. Don’t press the line under the cabinet or step on it. Take care not to roll on or damage 

the supply line when moves the machine from the wall.   

12. In the case of leakage of inflammable gases like carbon monoxide, open the door and 

windows. Don’t pull out or insert the plugs of the appliance. 

13. Don’t touch the refrigeration surface of the freezing compartment when the refrigerator is in 

operation, especially when your hand is wet, else you may be glued to the surface.