Name of Parts
Wire Controller
14.Network control display
Used to adjust the
time of timer and
clock
W h e n t h e w i r e
controller appears
abnormal condition,
use a sharp-pointed
article to press this
button to make the
w i r e c o n t r o l l e r
resume norma
After cleaning the air
inlet, press this
button, the unit can
start to operate
12.Humidifying state display
Used to turn on/off unit
1.ON/OFF button
6.Air filter cleaning display
*
7.Super/Soft operation display
13.Sleep state display
2.Temperature display
24.Time Adjusting
button
23.Sleep button
Used to set Sleep
s t a t e o r P o w e r
F a i l u r e R e s u m e
Function
When there is too much dust
collected on the air inlet, the
wire controller will show this
display to remind the user to
clean the air inlet. After
cleaning and installation, just
press the air filter reset button.
8.Fan speed display
9.Auto Swing display
11.Fresh air state display
25.Reset button
26.Air Filter Reset
button
27.Timer button
Used to set the mode
of timer
28.Lock state display
29.Electric heating
button
4.Timer ON/OFF display
3.Clock display
17.Operation mode button
5.Humidity display
22.Setting button
Used to confirm the
time of timer and
clock
15.Working mode display
21.Clock button
Used to calibrate the time of
timer and clock
16.Electric heating display
Used to set working mode:Auto,
Cooling, Dehumidifying
,
Heating, Fan
18.Fan speed button
Used to set fan speed: Low Fan,
Med Fan, High Fan, Auto
20.Temperature Setting button
10.Health state display
Used to set temperature,
temperature range
: 16
*
~30
*
19.Swing button
Used to set Auto Swing or Fixed
air sending direction
3
Calibration of clock
When turning on the unit for the first time, the clock should be calibrated. The method of
calibration is:
1.Press ìClockî button, the Clock display ìAMî ìPMî will flash.
2.Press
*
or
*
to adjust time. For each press, the time will increase or
*
decrease 1
minute. If depressing the button, the time will increase or decrease
*
rapidly.
3.After confirming the time, press ìSetî button, ìAMî or ìPMî will stop flashing, the
clock will begin to work.
Note:
1.This model does not have the following related display and function
2.Non-electric heating type, there is no electric heating button
and electric heating display
*
*
10 11 12 28
16
29
Auto
Low Fan Med Fan High Fan Auto
Working
mode
Auto
operation
Cooling
operation
Dehumidifying
operation
Heating
operation
Fan
operation
Wire
controller
29
MODE
FAN
SWING
TEMP
CLOCK
TIMER
SET
SLEEP
HEAT FILTER RESET
SET
ROOM
RESET
ON/OFF
1
2
3
4
5
6
7
8
9
11
12
13
14 15 16 17 18
20
21
22
23
24
25
26
27
28
AUTO
10
19
