English
English
6
ASSEMBLY INSTruCTIONS
Read carefully and understand all installation instructions before installing the
water dispenser.
Installing Your Water Dispenser
1. open the front door.
2. Untie the wire that holds the suctions pipe.
3. Remove the protective vinyl bag from the suction pipe.
4. Remove the plastic seal from a 5 gallon water bottle.
- Place the water bottle on the middle of the Bottle guide.
5. Then insert the suction pipe in the water bottle and make sure the cap is secure
on the bottle.
6. Roll back into the Cabinet. (Please install bottles that are at least half full.)
7. Close the front Door.
8. After inserting the power plug into a dedicated – 115V~60Hz power source
you should hear a pumping sound. for the first 5 seconds, the pump sound is
quite noticeable. This is normal so do not be alarmed. After 5
seconds, the sound will fade. Pump will start to supply water to tank.
9. After approximately 7 minutes, or when the water can dispense water from the
hot water tap, turn on the hot water switch in the back of the unit. The
cooling system will begin to operate as soon as the power cord is plugged in.
on some models, you need to turn on the cold water switch in the back of the
unit as well.
10. If the water level has not reached full level over a 10-minute period while the
pump is operating, the pump will stop, the “Empty” indicator light will flash,
and the unit will begin beeping.
11. When you open the door, the “Empty” indicator light will turn off and the
beeping will stop.
12. Please replace with a full bottle of water.
NOTE: Careful and proper handling of the tube, suction pipe and
bottle guide will ensure a longer lasting unit.
POWER INTERRUPTIONS
occasionally, there may be power interruptions due to thunderstorms
or other causes. Remove the power cord from wall outlet when a power
outage occurs. When power has been restored, re-plug the power cord
into wall outlet.
