7
English
English
OPErATING YOur WATEr dISPENSEr
This water dispenser maintains instant hot and cold water for your drinking and
cooking needs. It accepts 5 gallon water bottles.
Note:
The hot (red) water button is equipped with a
child safety lock
to
prevent accidental spilling of hot water. To release the hot water flow, the
lever must be pushed along with the child safety button, which is located
right over the water release tap.
Caution!
Be careful when carrying hot water in your cup or container to avoid
any injury or harm from spills.
Display Indicator lights:
HoT - Red
ColD - green
EMPTy - yellow
CHECKING POINTS
1. Check if the correct voltage is supplied to the cooler. (115V~60Hz)
2. Check if the cold indicator light turns “oN” when plugging the electric cord
into the wall outlet.
3. Check if the door is closed or not.
Note:
If door is not closed, the pump will not operate.
4. Check if the pump works properly by installing a water bottle and closing the
door.
5. Check if display lED lights up correctly.
Note:
When first plugged in (Power on), the Cold indicator light will be oN.
When Hot Switch is turned on, the Hot Indicator light will be oN.
rEPLACING THE BOTTLES
1. When water bottle is empty, the empty lED will start blinking and the
unit will alert you with a beep.
2. open the front Door.
3. Roll the Bottle guide out of the Cabinet.
4. Remove the cap with the suction pipe from the empty bottle and remove empty
bottle from the Bottle guide.
5. Place a new 5 gallon water bottle upright on the Bottle guide, insert the
suction pipe in the bottle, secure the cap and roll it back into the Cabinet.
6. Close the front Door.
