Haier AS07NS3HRA Operation Manual And Installation Manual Download

Page: 7 / 123

Operation

Air Flow Direction Adjustment

Base Operation

Remote controller

Emergency operation and test operation

Emergency Operation:

Use this operation only when the remote controller is defective
or lost, and with function of emergency running, air conditoner
can run automatically for a while.
When the emergency operation switch is pressed, the " Pi "
sound is heard once, which means the start of this operation.
When power switch is turning on for the first time and
emergency operation starts, the unit will run automatically in
the following modes:

It is impossible to change the settings of temp. and fan speed,It
is also not possible to operate in timer or dry mode.

temperature is below 16

C, do not use it in the

Test operation:

Use this switch in the test operation when the room

normal operation.

your finger from the switch: the cooling

Continue to press the test operation

switch for more than 5 seconds . After

you hear the "Pi" sound twice, release

Test ope ration switch is the same as emergency switch.

operation starts with the air flow speed "Hi".

Under this operation mode,the fan motor of indoor

unit will run in high speed.

Pi Pi

Room
temperature

Designated
temperature

Timer
mode

Fan

speed

Operation

mode

Above 23

AUTO

COOL

When restart after remote turning off, the remote controller

When adjusting the flap by hand,turn off the unit.

When humidity is high,condensate water might occur

It is advisable not to keep horizontal flap at downward
position for a long time in COOLor DRY

otherwise, condensate water might occur.

adjusted to left or at air outlet if all vertical louvers are right.

mode ,

controller will automatically memorize the previous set swing position.

Note:

1.Status display of air flow

2.Left and right air flow adjustment

Pos.1

Pos.2

Pos.3

Pos.4

Pos.5

Pos.6

For each press of

button, remote controller

displays as follows :

remote controller:

For each press of

button, remote controller

displays as follows :

remote controller:

Cautions:

Remote controller:

Press

button

Every time the button is pressed, temp.setting
increase 1

C,if kept depressed, it will increase

rapidly

Every time the button is pressed, temp.setting

decrease 1

C,if kept depressed, it will

decrease rapidly

Select a desired temperature.

3.Fan function

2.Select temp.setting

Air conditioner is running under displayed fan speed.
When FAN is set to AUTO, the air conditioner
automatically adjusts the fan speed according to room
temperature.

Unit start

Press ON/OFF on the remote controller, unit starts.

changes as follows:

LOW

MED

Display
circulated

For each press button fan speed

In HEAT mode,warm air will blow out after a short
periodof the time due to cold-draft prevention function.

When FAN is set to AUTO, the air conditioner automatically
adjusts the fan speed according to room temperature.

Cooling only unit do not have displays and functions
related with heating

Remote

Controller

Note

COOL

DRY

HEAT

FAN

In DRY mode, when room temperature becomes
lower than temp.2

C,unit will run intermittently

at LOW speed regardless of FAN setting.

Under the mode of auto operation, air conditioner will
automatically select Cool or Heat operation according
to room temperature.

air conditioner automatically adjusts the fan speed

temperature.

When FAN is set to AUTO, the

according to room

In FAN operation mode, the unit will not operate in
COOL or HEAT mode but only in FAN mode ,AUTO is
not available in FAN mode.And temp.setting is disabled.

In FAN mode,SLEEP operation is not available.

Operation

Mode

AUTO

Press button to enter additional options, when

cycle display to , will flash. And then press

enter to FAN function.

Swing

Temp+

Temp-

Health

Extra Function