Haier AS12GB3HRA, Service Manual

System configuration

29

Domestic air conditioner

Operation

1.After unit starts, select your desired operation mode.

2.Press TIMER button to change TIMER mode. Every
time the button is pressed, display changes as follows:
Remote controller:

BLANK

TIMER ON

TIMER OFF

TIMER ON-OFF

Then select your desired TIMER mode (TIMER ON or
TIMER OFF or TIMER ON-OFF). "        "or "       "will flash.

3.Press        / 

button to set time.

It can be adjusted within 24 hours.

Hints:
After replacing batteries or a power failure happens, time
setting should be reset.

According to the Time setting sequence of TIMER ON or

TIMER OFF, either Start-Stop or Stop-Start can be achieved. 

 Timer On/Off  On-Off Operation 

CE

All the products are in conformity with the following 
European provision:
- Low Voltage Directive 73/23/EEC
- Low Voltage Directive 2006/95/EC
-Electomagnetic CompatibilitY 89/336/EEC
-Electomagnetic CompatibilitY 2004/108/EC 

ROHS

The products are fulfilled with the requirements in the 
directive 2002/95/EEC of the European parliament and of
council on the Restriction of the use of Certain Hazardous
Substances in Electrical and Electronic Equipment (EU 
RoHS Directive)

WEEE

DISPOSAL REQUIREMENTS:

Your air conditioning product is marked with this
symbol.This means that electrical and electronic
products shall not be mixed with unsorted 
household waste. Do not try to dismantle the 
system yourself : the dismantling of the air

EUROPEAN REGULATIONS
CONFORMITY FOR THE MODELS

1

1+2=

kg

R410A

2

kg

2=

1=

B

C

D

F

E

kg

A

This product contains fluorinated greenhouse gases covered by 
the Kyoto Protocol. Do not vent into the atmosphere.
Refrigerant type:R410A
GWP* value:1975
GWP=global warming potential
Please fill in with indelible ink,
• 1      the factory refrigerant charge of the product
• 2      the additional refrigerant amount charged in the field and
• 1+2  the total refrigerant charge
on the refrigerant charge label supplied with the product.
The filled out label must be adhered in the proximity of the product
charging port (e.g. onto the inside of the stop value cover).
A  contains fluorinated greenhouse gases covered by the Kyoto 
Protocol
B  factory refrigerant charge of the product: see unit name plate
C   additional refrigerant amount charged in the field
D   total refrigerant charge
E   outdoor unit
F   refrigerant cylinder and manifold for charging 

IMPORTANT INFORMATION REGA-
RDING THE REFRIGERANT USED

In accordance with the directive 

2002/96/CE

of the European

parliament, herewith we inform the consumer about the dis-
posal requirements of the electrical and electronic products.

conditioning system,treatment of the refrigerant, of oil and of
other part must be done by a qualified installer in 

accordance

with relevant local and national legislation. Air conditioners 
must be treated at a specialized treatment facility for reuse, 
recycling and recovery. By ensuring this product is disposed 
of correctly, you will help to prevent potential negative cons-
equences for the environment and humen health. Please 
contact the installer or local authority for more information. 
Battery must be removed from the remote controller and dis-
posed of separately in accordance with relevant local and 
nationl legislation.

Contains fluorinated greenhouse gases
covered by the Kyoto Protocol

 Healthy airflow Operation

1.Press          to starting

Setting the comfort work conditions.

2.The setting of healthy airflow function

Note:

1.After setting the healthy airflow function, the position

 grill is fixed.

4.In cooling and dry, using the air conditioner for a long

time under the high air humidity, condensate water may
occur at the grille .

3.The cancel of the healthy airflow function

Notice: Do not direct the flap by hand. Otherwise, the
grille will run incorrectly. If the grille is not run correctly, stop

for a minute and then start, adjusting by remote 
controller.

2.In heating, it is better to select the
3.In cooling, it is better to select the

mode.

mode.

TIMER OFF-ON

0.5h

0.5h

0.5h

0.5h

Press the button for each time, setting time in the first 
12 hours increased by 0.5 hour every time, after 12 
hours,increased by 1 hour every time.
Press the button for each time, settiing time in the first 
12 hours decreased by 0.5 hour every time, after 12 
hours,decreased by 1 hour every time.

After adjust the time,press          button and confirm the
time ON or OFF button will not flash any more.

4.Confirm timer setting

5.Cancel timer setting
Press the timer button by times until the  time display 
eliminated.

Press           button to enter additional options,Press this 
button continuously, the louvers location will cycle between 
in the following three locations, to choose the swing location 
what you needed,and then press          button to confirm.

Press          button to enter additional options,Press this 
button continuously, the louvers location will cycle between 
in the following three locations again,and then press
button to cancel.

Healthy
airflow
upwarder

Healthy
airflow
downwarder

Present
position