OFF
OFF
DRAIN
STANDARD
GENTLE
MAX
Washing sequence
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Spin timer
SPIN TIMER
SPIN
WASH
Wash timer
WASH SELECTOR
Wash selector
Buzzer
BUZZER
Water-filling entrance
(To set to below 2 minute,
first set to 5 minute then
turn it back. it can increase
the service life of the timer).
Using process
Using process
(gentle current,
standard current)
(The buzzer will ring when
the washing finishes)
(to set to below 1 minute,
first set to 2 minute then
turn it back. it can increase
the service life of the timer).
Overfilling sign
Water-filling selector handle
Wash
DRAIN
DRAIN
STANDARD
STANDARD
GENTLE
GENTLE
WASH SELECTOR
WASH SELECTOR
1.Water-filling selector
(1) Set the water-filling selector at the "WASH" side.
(Figure 1)
(2) Fill the water and add the dissolved washing
powder to make the water level reach the preset
position. (Figure 2)
Run washing program for some time to stir and
dissolve the powder completely.
2.Put in the laundries. If the water quantity is
insufficient, please add water.
3.Select the current.
Select the" STANDARD" or "GENTLE "current
according to the laundries. (Figure 3)
4.Select the washing time
Select the washing time according to the laundries.
(Figure 4)
5.After washing, the buzzer alarms. Set current change
at "DRAIN"position. (Figure 5).
WASH TIMER
WASH TIMER
OFF
OFF
WASH
WASH
SOAK
SOAK
Remarks:
1. 0~15 minute is the normal soaking.
2. 15~45 minute is active soaking. During active soaking, the pulsator will run for 2 minutes
in each 8 minutes. After the active soaking, it will run normal washing for 15 minutes.
3. If you select soaking(i.e. turn the knob to position between 15~45 minutes), be sure to
dissolve the washing powder in advance, otherwise the washing powder may result in
damage to the laundries.
