Please install and adjust the machine according to the requirement of the manual.
It is very important to your security and correct operating the machine.
Usage of the drain hose
The drainage shall be smooth with the drain hose.
Before Using
Before Using
Installation and adjustment
Install the water inlet hose; Select the water level
(about 46L)
High
High
(about 55L)
Low
Low
(about 36L)
Medium
Medium
Adjust the water level adjusting
lever to desired water level line.
Water inlet hose
Water-filling
entrance
Water level
adjusting lever
4.If extra drain hose is needed , the inner
diameter of the extra hose shall not less
than 30mm, and the length shall not exceed
1.5m.
<10cm
> 30mm
<1.5m
1.The height of the drain hose shall be
less than 10cm , or the drainage will
not be smooth enough and cause
incomplete drainage.
2.Do not step on or press the drain hose.
3 If the drain hose is too long, cut it at mid
point. To make smooth drainage, cut the
front end of the hose slantingly.
Insert the water inlet hose into the water-filling
entrance on the control panel directly. (pull it
out to dismantle it)
Select water level according to the
quantity of the laundries.
Attention:
In water filling, do not exceed
the"High" water level. Otherwise
the water may overflow out of the
washing machine.
Lint filter
Filter frame
After opening the package,please take out the lint filter from
the document bag,install it to the filter frame of the
cabinet.See to the figure.
Install the lint filter
