3
8
6
Please fasten the drain hose to the pressure relief
hole of the safety valve by twisting (see to Figure 4).
Connect the other end of drain hose to the sewer to
avoid polluting the room by splashing. When the
power is switched on, and the water heater starts
operating, there may be some water discharged
from the pressure relief hole of the safety valve. It is
due to the water expansion under heating, and is a
normal phenomenon. The pressure relief pipe shall
communicate with the air directly. Do not block it.
The drain hose connecting to the safety valve shall
be kept downward sloping in installation and in a
frost-free environment.
Be sure to check and confirm that the tank is filled
with water, there is no leakage at each joint and the
power supply complies with the stipulation before
switching on the power.
Connect to drain hose
(Figure 4)
In case the power cord of the water heater is
damaged, be sure to have it replaced by after
service technicians with the special cord offered
by the manufacturer.
Check if the ammeter and the diameter of the wires are in
accordance with the rated current of the water heater. If
necessary, please have it checked by an experienced
electrician.
This water heater is available for AC 230/50Hz
power.
Be sure to use independent socket and earth it reliably,
and socket quality shall conform to the national standard
requirements.
The product adopts the patented “Safe Care” technology of our company. As long as product adopts
civil power supply, even if the earthing wire is electrified by mistake, the “Safe Care” technology still can
block dangerous electricity, and ensure your personal safety. But if you find any perceptible current,
please disconnect the power and contact after service department for maintenance. Do not
disassemble by yourself.
Description of the Symbols
Never do that.
Be sure to act as per instructions.
Set the power socket of the water heater at the
dry position away from spraying water. Do not
plug/unplug with wet hands.
During winter in a cold area, if the heater is idle for a long
period, please pull the handle of the safety valve to
discharge the water. Otherwise it may freeze inside the
water heater and cause damage.
After installation, be sure to fill the heater completely with
water before switching on the power in the first usage.
Children must take a bath under the supervision of adult.
In opening and closing the water valve, do not
point the showerhead toward the human body.
Otherwise it way hurt by the spraying hot water.
During heating, water may drip from the drain hose of the pressure relief hole due to
expansion and the hole must be left open to the atmosphere. Check safety valve
once a month as follows: move the small handle of the safety valve, if there is water
flowing out, the safety valve is normal; if there is no water flow, please contact local
after-sales service station.
The pressure relief hole is to be operated regularly to remove lime deposits and to
verify that it is not blocked.
Safety Precautions
Installation
Attention during installation
Safety Precautions
Installation Attention during installation
V
23
0
5H0z
Safety precautions:
1. Do not confuse the water inlet and outlet pipes. The water bearing the water heater shall
be strong enough to endure a weight twice as much as that of a water heater filled with
water. Do not secure it by means of adhesive or similar products because the fixation by
such methods is unreliable.
2. To avoid danger caused by accidental resetting of the heating breaker, the power for the
heat cannot be supplied by timer and other external switch devices or connected to circuit
with frequent switching for facility use.
3. If any part is damaged, please contact the local maintenance agent and have it replaced
with our spare parts.
4. Tap water inlet pressure shall be no less than 0.05MPa and the maximum pressure shall
not exceed 0.75MPa.
All manuals and user guides at all-guides.com
