10 - Installation
EN
22
10.9 Door Reversibility
Before connecting the appliance to the power supply you should check, whether the door
swing must changed from right (as delivered) to left, if this is required by the installation
location and the usability.
WARNING!
▶
The appliance is heavy. You need two persons to carry out the door reversibility.
▶
Before any operation, first unplug the appliance from the mains .
▶
Do not tilt the appliance more than 45 ° to prevent damage of the cooling system.
1. Provide necessary tool.
2. Unplug the appliance.
3. Remove hinge hole cover and hinge cover.
4. Unplug the connection cable.
5. Removes screws and hinge
6. Remove cover on door. Remove axe cover on
door
7. Open and remove the door.
8. Turn the door upside down, remove 2 screws on
the bottom of the door. Remove 2 screws, door
stopper and axe cover on the bottom of the door
9. Take door stopper from last step and the thinner
axe cover from the accessory bag, fix them with 2
screws. Fix 2 screws also on the other side of the
door.
10. Tilt slightly backwards the cabinet, remove 4
screws and then the lower hinge.
Assembly steps
(Fig. 10.9):
1
2
10.9
10
3
4
6
5
7
8
9