English
Installation, Use and Maintenance Manual - HACI-RP DX series
pag. 37
SECTION 2 - TRANSPORT
2.1 Packing
• The regenerators and their accessories are inserted in cardboard boxes that will have to remain integral until the moment of the assembly.
• The components that, due to technical requirements, are not assembled, are supplied packed in a suitable covering and fixed to the inside or
outside of the unit.
2.2 Handling and transport
• For the handling, in function of the weight, use adequate means in conformity to the directive 89/391/EEC and successive modifications.
• The weight of every single machine is shown on the attached technical data sheet.
• Avoid rotations without control.
• Take utmost care during loading operations: all the machines must be loaded and stored in the truck interposing opportune spacers to safe-
guard all protruding parts like water couplings, handles, hinges.
2.3 Control upon reception
Upon reception of the goods, please carry out a control of all the parts, verifying that the transport has not caused damages. All damages must
be communicated to the carrier, putting a reserve clause on the delivery note and specifying the type of damage.
2.4 Storage
In case of long term storage, keep the machines protected from dust and from all sources of vibrations and heat.
The manufacturer company declines every responsability for damages due to uncorrect unloading or not sufficient protection
against atmospheric agents.
SEZIONE 3 - INSTALLATION AND START UP
3.1 Definitions
CUSTOMER
- The customer is the person, the agency or the company, that has acquired or rented the unit and that uses it for the conceived
purpose.
USER / OPERATOR
- The operator or user is the physical person who has been authorised from the customer to operate with the machine
SPECIALISTIC STAFF
- Intended are all those physical persons who have achieved a specific training, are therefore in a position to recognize
the dangers deriving from the use of this machine and are able to avoid them.
3.2 Safety Standards
The Manufacturer/Distributor Company declines whichever responsability for the non observance of the emergency and prevention norms
described below.
It declines furthermore responsibility for damages caused by an improper use of the unit and/or by modifications carried out without authoriza-
tion.
• The installation must be carried out by expert and qualified staff.
• During installation operations, use suitable accident-prevention clothing, as an example: glasses, gloves, etc as indicated by the 686/89/EEC
and successive norms.
• During installation, operate in absolute safety, in clean surrounding and free from impediments.
• Respect the laws in force in the Country in which the unit is installed, concerning the use and the disposal of the packings and the products
used for cleaning and maintainig the machine and follow the manufacturer instructions of such products.
• Before putting the unit in function, check the perfect integrity and safety of all components and of the entire system.
• Avoid at all cost to touch the parts in motion or to intefere with the same ones.
• Do not proceed with cleaning or maintenance operations, before switching off the electric power supply.
• The maintenance and the substitution of damaged or worn out parts of the unit must be carried out by qualified staff only and following the
indications contained in this handbook.
Summary of Contents for HACI-RP DX 100
Page 52: ...2020 06 ...
