GB 59
Electrical Connection
1500+900 W
1200 W
1200 W
1000+700 W
1
According to model
1.
ON/OFF
2.
" + "
3.
" - "
4.
TIMER
5.
Additional cooking zone led
6.
Cooking zone programming indicator
7.
Child lock
C
B
D
A
LAYOUT 1
LAYOUT 1
LAYOUT
"Installation must conform to the standards &
directives."
Manufacturer declines all responsibility for any
damage that might be caused by unsuitable or
unreasonable use.
WARNING:
Manufacturer cannot be held
responsible for any incident or its consequences
that may arise during the use of an appliance not
linked to the earth, or linked to an earth whose
continuity is defective. Before any electrical
operation, please check the supply tension shown
on the electricity meter, the adjustment of the
circuit- breaker, the continuity of the connection
to earth to the installation and that the fuse is
suitable.
The electrical connection to the installation
should be made according to the rated power of
the Appliance; this should be made via an Omni
pole cut-out switch.
If the appliance has a socket outlet, it must be
installed so that the socket outlet is accessible.
The yellow/green wire of the power supply cable
must be connected to the earth of both power
supply and appliance terminals.
For any questions regarding power supply cord
refer to After Sales Service or a qualified technician.
If the hob is fitted with power supply cord, this shall
be connected only to a power supply of 220-240 V
between phase and neutral.
It is however possible to connect the hob to:
Three Phase 220-240 V3
Three Phase 380-415 V2N
To proceed to the new connection, please follow
below instructions:
Before making the connection, make sure that the
installation is protected by a suitable fuse, and that
it is fitted with wires of a large enough section to
supply the appliance normally.
Turn over the hob, glass side against the working
top, taking care to protect the glass.
Open the cover in the following sequence:
2
3
1
- unscrew the cable clamp "1";
- find the two tabs located on the sides;
- put the blade of a flat screw-driver in front of
each tab "2" e "3", push in and press;
- remove the cover.
To release the power supply cord:
- Remove the screws retaining the terminal
block which contains the shunt bars and the
conductors of the supply cord;
- Pull out the supply cord.
8 8
4
8
2
3
6
8
2
3
7
1
8
2
3
8
2
3
6
5
5
Summary of Contents for HAH 64 EXCP
Page 1: ......
Page 70: ...42837632 12 2020 Rev_0 ...
