13
INSTALLATION INSTRUCTIONS
IMPORTANT: This appliance shall be installed only by authorized persons and
in accordance with the manufacturer’s installation instructions, local gas fitting
regulations, municipal building codes, electrical wiring regulations, local water
supply regulations.
STEP 1 - UNPACK RANGE
WARNING
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
1. Remove shipping materials, tape and film from the range. Keep cardboard
bottom under range. Do not dispose of anything until the installation is
complete.
2. Remove oven racks and parts package from oven and shipping materials.
3. To remove cardboard bottom, first take 4 cardboard corners from the carton.
Stack one cardboard corner on top of another. Repeat with the other 2 corners.
Place them lengthwise on the floor behind the range to support the range when
it is laid on its back.
4. Using two or more people, firmly grasp the range and gently lay it on its back on
the cardboard corners.
5. Remove cardboard bottom.
NOTES:
•
The leveling legs can be adjusted while the range is on its back.
•
To place range back up into a standing position, put a sheet of cardboard or
hardboard on the floor in front of range to protect the flooring. Using two or
more people, stand range back up onto the cardboard or hardboard.
STEP 2 - INSTALL BACKSPLASH
For proper ventilation and to protect your wall from splatters, install the backsplash
to the rear edge of the cooktop which extends past the back of the oven.
Parts Provided: Screws (6)
NOTE: 24" model uses (4) screws and the 36" model uses (6) screws
1. Align the holes in the backsplash with the holes in the back edge of the cooktop.
2. With one person holding the backsplash, and working from underneath the
extended rear edge, insert screws through the bottom of the cooktop and into
the bottom of the backsplash. Tighten completely.
Summary of Contents for HCR6250AGS
Page 2: ......
