Switch dishwasher ON.
Immediately press the delayed start button "F". The delayed start indicator "E" blinks and the time
remaining indicator "G" changes to " ".
Press the delayed start button for 2 seconds until the numerical display shows the required delay.
To cancel the time delay setting, press the delayed start button until the delayed start indicator “E"
goes out.
Rotate programme dial "J" to select the desired programme.
18
End of programme
Six beeps will indicate that the wash cycle has finished and the indicator light "A" comes on.
Switching the dishwasher OFF
Several minutes after the programme has ended:
Set On-Off button to Off.
Open the door.
Remove dishes, etc. when they have cooled down.
Interrupting the programme
Open the door. Caution! There is a risk of water coming out from inside the appliance. Do not open the
door fully until spray arm has stopped rotating.
When you open the door, the dishwasher will beep ten times every thirty seconds until door is closed
or programme cancelled.
If the appliance has already heated up or the hot water was switched on and then the appliance door
was opened, leave the door ajar for several minutes before closing. Otherwise, the appliance door
may not close properly due to expansion.
Delayed start programming
You can delay the start of a programme in increments of 1 hour up to 24 hours.
POWER
3 in 1
DELAY
HEAVY
NORMAL
LIGHT
GLASSWARE
PRE-RINSE
RINSE
QUICK 30
1
2
3
4
5
6
7
B
A
D F
C
G
E
I
H
HEAVY
NORMAL
LIGHT
GLASSWARE
PRE-RINSE
RINSE
QUICK 30
1
2
3
4
5
6
7
J
en
Close the door after loading the appliance.
Notice:
If the programme is already underway press the ON-OFF button "B" for 3 seconds. All
of the settings will be cancelled.
