Haier HDY-D70, ‫دليل االستخدام

The following must be confirmed before calling for service:

Problem

The dryer does not 
start

Possible Cause

● Is the power supply plugged in and switched on.
● Plug another appliance into the wall socket to
 test if there is power.
● Check if a drying program has been set;
● the Start/Pause button has been pressed;
● The water collection box is full;

The drying result is not 
good and the drying 
time is too long. 

●Is the drying program setting  correct;
●Has the filter screen been cleaned ;
●Is the condenser blocked;
● Does the amount of the loaded laundry 
exceed the rated load; 
● Has the loaded laundry been spun dry;
●Is the vent duct blocked;
● Has the surface of the inside of the drum 
 got a deposit layer forming, if so clean the 
 drum interior;

The remaining time 
display is halted, or the 
remaining time displayed 
is skipping 

The remaining time will be adjusted and corrected 
continuously and automatically based on the 
following factors:
●Type of laundry;
●Loaded amount;
●The degree of spinning dry of laundry;
●Ambient temperature;
The automatic adjustment is a normal operation.

E2

E5

E6

Prompt and Alarm Information

  In case of an improper operation or trouble with the machine when it 
operates, the code corresponding to the trouble will be displayed on the 
screen:

Code

Category

Cause

Solutions

Trouble code

Trouble code

Trouble code

There is no change in
 the temperatures of
 the laundry in the tub

Contact a professional 
       serviceman

The thermal sensor 
open-circuited or short 
circuited

Contact a professional 
       serviceman

Drain pump fails

Contact a professional 
        serviceman 

Start the dryer,but it 
does not start and the 
screen displayed “End”.

●Is the door closed tightly;
●The loaded laundry has reached the requirmrnts
      for the drying setting.
●Is there load into the tub;

Trouble shooting

Trouble shooting