Haier HFH-50, Service Manual

been found ,repair them or replace them with new parts according to specific circumstances ,then 

evacuate the system and finally charge refrigerant.   

2)    Refrigerating system has been clogged   

a)  Clogged with Ice  

ANALYSIS OF TROUBLE   

The dryness treatment for the major parts in the refrigerating system has been performed improperly, 

the effect of air purging for the whole system is not good ,or the water content in the refrigerant is out of 

standard ,all these will cause the expansion valve to be clogged with ice .The symptom for this trouble 

are as follows :the refrigerator sometimes can refrigerate and sometimes cannot :the refrigerator 

compartment works normally at the beginning ,but after working for a certain period of time ,frosting 

begins at the clogged position ,evaporation temperature reaches below 0 

℃

, water will accumulate at 

the narrow part of the capillary and clog it gradually ,then frost begins to melt at the evaporator ,no gas 

flowing sound can be heard ,and the gas suction pressure assumes a state of vacuum .Note that these   

phenomena will appear intermittently ; sometimes ,the   

refrigerator works well ,and sometimes not well .In order to determine whether it is clogged with 

ice ,heat the suspicious points with hot water to make ice melt ,and after a while if a gas flowing sound 

resulting from an abrupt gush is heard and the gas suction pressure rises as well ,it can be confirmed 

that the trouble is caused by ice clogging .   

REMEDY  

If there is too much moisture in the refrigerating system, it is advisable to release the refrigerant, purge 

the tubing with nitrogen, and then charge the system with the filtered refrigerant. However, the 

commonly adopted method is to connect a filter with moisture absorbers (such as silica-gel, anhydrous 

calcium chloride) to the refrigerating system so as to filter out the moisture from the system, then 

replace the filter, evacuate it again and   

finally charge the system with refrigerant.   

b) Clogged with dirt in capillary   

ANALYSIS OF TROUBLE   

The capillary inlet is a place where coarse-grained dirt or refrigerant oil in the system will tend to settle 

down and clog it. In case considerable dirt accumulates there, the whole filter screen may be blocked 

totally, making the refrigerant unable to go through. Clogging with dirt exhibits the same symptoms as 

that with ice, namely, higher gas suction pressure, lower temperature of discharged gas, and no gas 

flowing sound from the evaporator. The difference between the both is as follows: if the clogging is 

caused by dirt , tapping the suspicious clogged point (generally in the capillary or the connection joint 

of the filter) may cause the refrigerant to flow through partially, resulting in some corresponding change, 

whereas in that case if you heat it with a hot towel, no reaction will happen, no flowing sound can be 

heard, moreover, there is no periodic change. After rejecting the possibility of ice clogging, it can be 

generally considered as the clogging due to dirt .   

REMEDY  

Dismantle the system, remove the dry filter from it, purge the tubing with nitrogen, install a new filter, 

then evacuate it and finally charge it with refrigerant.   

C) Clogging in filter   

ANALYSIS OF TROUBLE 

Total clogging of a filter is rarely to occur. This trouble is mostly caused by the paste-like matter formed 

from the substances filled into the system or other dust after the refrigerator has been used for a