18
MAINTENANCE
DISPLAY CODES
DISPLAY CODES AND SPECIAL FUNCTIONS
¬ Control panel lock function: Press the "Delay" and the "Temperature" buttons simultaneously for 3 seconds after starting a program.
It can no longer be changed by operating buttons or knobs. To unlock press the "Delay" and "Start/Pause" buttons again for 3
seconds.
¬ Power-off memory function: In case of abrupt power failure or the need to cut off the power during a program cycle, the present
settings will be saved and the preset operation will resume when the power is on again.
¬ To cancel a program
Press the "Start/Pause" button, then switch off the power and the program is automatically cancelled. Turn the program selector
again to choose another program.
CODES
CAUSES
SOLUTIONS
Err1
¬ Door is not properly shut.
_ Shut the door properly.
Err2
¬ Drainage error, water not emptied within 4
minutes.
_ Clean the fi lter and check the drain hose for blockage. If error
still exists, please contact the maintenance personnel.
Err3
¬ Temperature sensor not properly connected or
damaged.
_ Contact the maintenance personnel.
Err4
¬ Heater error (Appears at the end of a cycle).
_ Reduce load and then start washing again. If problem still
exists, please contact the maintenance personnel.
Err5
¬Water level not met in 8 minutes.
¬The height of the drain hose is below 80 cm.
¬ The drain hose is in water.
_ Make sure that tap is turned on, and water pressure is normal.
If problem still exists, please contact the maintenance personnel.
_ Install drain hose within 80-100 cm of height.
_ Make sure the drain hose is not in water.
Err7
¬ Motor overheat protection or damage.
_ Contact the maintenance personnel.
Err8
¬ Water exceeds protective level.
_ Contact the maintenance personnel.
End
¬ End of wash cycle.
1:25
¬The remaining time is 1 hour 25 minutes.
Unb
After the last rinsing cycle fi nishes,spining fails
completely due to an imbalance of the laundry
Redistribute laundry to balance the drum
