A) Filament Bulb/Lamp and replacement
Lamp: 200V, 15W
Lamp holder: E14 (lamps exceeding 15W
must not be allowed)
When replacing the lamp,
1. Unplug to disconnect the power
2. Remove the food shelf in front of the lamp.
3. Insert a flat tool into the slot Push upward to
remove the lampshade.
4. Remove the lamp by turning anti-clockwise and
install a new lamp by lamp by turning it clockwise.
5. Properly install the lampshade after ensuring
that all legs on the cover are placed into the holes
on the lamp holder.
B) LED Lamp and replacement
Lamp: 220V, 1.5W (1 Unit Assembly)
When replacing the LED,
1. Unplug to disconnect the power
2. Remove the food shelf in front of/below the
lamp.
3. Insert a flat tool into the slot Push upward to
remove the lampshade.
4. Disconnect the LED Thimbles and pull out the
LED from slot.
5. Install a new LED and fit in slot and connect the
thimbles again.
6. Properly install the lampshade after
ensuring that all legs on the cover are
placed into the holes on the lamp holder.
* For top mounted LED lamp, same method will
be followed.
Note:
CSD technician should follow (A) or (B) according to unit, LED lamp / Filament Lamp Should be haier recommended.
13
12
The refrigerator is for
short term food storage of
daily consumption