SERVICE MANUAL
Model:
HRF-265F
9
Issue
20090827
Rev.
Ref0908S006V0
Chapter 3 Installation and Disassembly
3-1Build-in Installing
1. Ensure that the doors of the kitchen unit and the
refrigerator are of the same opening direction.
(Take the right-opening door as an example)
2. Fix the joint sockets to the freezer and
refrigerator doors with the provided screws
(Figure 1).
3. Move the refrigerator into the kitchen unit,
ensuring the left side panel of the refrigerator as
close as possible to the wall. (Figure 2)
4. Insert the connecting pad into the joint socket
and then fix the connecting pad on the door of
the kitchen unit with a margin of 20-22mm.
(Figure 3)
5. Properly place the refrigerator with a 3-4mm
space between the left side to the wall, ensuring
that the doors of the refrigerator and the kitchen
unit can be easily opened and closed, and the
connecting pad is correctly settled in the joint
socket.
6. Fix the upper and lower stiffeners to the upper
connection and base panel. The screw holes
shall be plugged with the plastic stoppers.
(Figure 4)
7. Fill the left gap of the kitchen unit with the
gasket.(Figure 5)
8. Remove the screws and the hole stoppers on
the left of the middle connection, and fix the
connecting pivot to the refrigerator with one end
in the hole which was plugged by the stopper
and the other end to the inside wall of the
kitchen unit. (Figure 6)
gçáåí=ëçÅâÉí
cáÖìêÉ=N
OMúOOãã
C
`çååÉÅíáåÖ=é~Ç
cáÖìêÉ=P
cáÖìêÉ=O
mä~ëíáÅ=ëíçééÉê
Çççê=Ö~ëâÉí
cáÖìêÉ=Q
cáÖìêÉ=R
cáÖìêÉ=S
