If any fuse (or Fusible Resistor) in this TV receiver is blown, replace it with a
specified one.
When replacing a high wattage resistor (Oxide Metal Film Resistor, over 1W), keep
the resistor 10mm away from PCB.
Keep wires away from high voltage or high temperature parts.
Due to the high vacuum and large surface area of the picture tube, extreme care
should be taken in handling the Picture Tube. Do not lift the Picture Tube by its Neck.
X-RAY Radiation
Warning:
The source of X-RAY RADIATION in this TV receiver is the High Voltage Section and
the Picture Tube.
For continued X-RAY RADIATION protection, the replacement tube must be of the
same type as specified in the Replacement Parts List.
Before returning the receiver to the customer,
Always perform an AC leakage current check on the exposed metallic parts of the
cabinet, such as antennas, terminals, etc., to make sure that the set is safe to
operate without any danger of electrical shock.
4
Summary of Contents for HS-2190
Page 31: ...Note the item marked have been adjusted on product line those may differ in different TV 31 ...
Page 40: ...Terminal view of transistors 2SC4237 2SD1879 2SA608 2SC536 2SB764 2SD400 40 ...
Page 43: ...C Circuit diagrams 43 ...
Page 61: ...Sincere Forever Haier Group Tel 86 532 8938356 Web site http www haier com ...
