English
Door Alignment
1. Remove the top hinge cover using a flat head screw driver. Gently lift from
the rear of the hinge and slide forward.
2. Loosen the top hinge screws using a phillips head screwdriver.
3. Adjust the door or put a spacer in between and then tighten the screws.
4. Replace the top hinge cover by sliding the hinge cover from front and press
gently on the rear of the hinge cover to lock.
Reversing the Door Swing
1. Remove the top hinge cover using a flat head screw driver. Gently lift from
the rear of the hinge and slide forward. (see fig.1)
2. Using a Phillips Head Screwdriver, loosen and remove the screws holding
the top hinge in place. (see fig. 1)
3. Remove the top hinge and carefully lift off the door.
4. Remove the screw hole plug from the opposite side and insert the plug in the
screw hole openings of the just removed screws. (see fig. 2)
5. Loosen the screws holding the lower hinge bracket and remove the
hinge.(see fig. 3)
6. Remove the screws from the bottom of the front-left corner plate.
7. Align the holes in the lower hinge bracket to the corresponding holes in the
opposite side of the cabinet bottom. Insert
and tighten the screws. (see fig. 3)
8. Align the bottom hole on the left side of
the door with the pin of the lower hinge
and slide into place.
9. Align the pin of the top hinge with top
hole on the left side of the door and push
into place. Replace the screws in the
upper hinge bracket but do not tighten all
the way. (see fig. 2)
6
fig.1
fig.2
English
English
