Front Load Washing Machine
Model:HVS SERIES
Page 22
Failure:no draining
Troubleshooting:
Failure :abnormal noise and vibration
Troubleshooting:
Turn filter anticlockwise
ˈ
open and check if
filter is jammed
Clean and tighten filter clockwise.
Turn on and choose spin program to
start. Measure if export voltage of PCB to
drain pump is 220
Y
Is the pack screws dismantled?
Dismantle the screws
Clean
N
Is the height of drain pipe too high?
N
Adjust the height of drain pipe to
80-100 cm
Y
Y
Y
Arrange hose and clean
Check if hose connecting cylinder to pump is
bent or jammed
Turn on power and choose spin program to start.
Measure if import voltage of drain pump is
220-240V
N
Y
Adjust adjustable feet
Is washer in balance?
Y
Turn on power and set spin program,
then start
ˈ
check if there is different noise
from motor
Cut off and check if the connection between
drain pump and PCB is open
Replace drain pump
Y
N
Replace the wire.
N
N
Replace
PCB
Is belt loose or worn?
N
Are the screws of counterweight and
motor loose?
Remove belt and turn belt pulley by
hand, and then check if there is different
Y
Y
N
Is there foreign material in the washer?
Replace it
N
Y
Y
Fasten them
Dismantle triangle and check
the
bearing
.If
it
is
broken, replace it.
N
N
Replace motor
-240