5
Installation Limitations
• Do not install your wine cellar in any location not properly insulated or heated
e.g. garage etc.
• Select a suitable location for the wine cellar on a hard even surface away from
direct sunlight or heat source e.g. radiators, baseboard heaters, cooking
appliances etc. Any surface unevenness should be corrected with the leveling
legs located on the front and rear bottom corners of the wine cellar. Avoid
placing unit where there may be electrical interference.
• Your wine cellar is designed for
free-standing installation only
. It is not
designed for built-in application.
NOTE: To minimize the risk of rusting, leakage and insulation
damage, avoid placing the unit in a place where heavy
moisture is present. Under no circumstances spill or directly
apply water onto or into the unit.
Door Alignment
1. Remove the top hinge cover using a flat head screwdriver.
2. Gently move wires aside and loosen the 3 screws using a Phillips Head
Screwdriver.
3. Adjust the door and tighten the screws.
4. Replace the top hinge cover.
5. Adjust bottom hinge if necessary.
Stabilization Bracket (HVTM04ABB ONLY)
To increase product stability we strongly recommend attaching the stabilization
bracket to the underside of the wine cellar.
1. Remove the bracket and 3 screws from the plastic bag.
2. Insert the screws through the holes in the bracket and then into the predrilled
holes on the bottom of the wine cellar (see image)
3. Tighten the screws
English
