Service Manual
Model No:HW60-1281S/1081
Issue
Rev.
15
Error message:The required water level is notreached within 8 min.
Error message:Motor speed error .it may be not properly connected
or damaged.
Check if water is leaking from washer
bottom. inlet pipe. drain pipe or other
pipe connection.
Check if tap is closed or water
pressure is too low.
Check if the inlet value is jammed.
Draw out the dispenser and check if
water is entering.
Turn on power, and set pre-wash
mode, then start. Check the import
voltage of electromagnetic valve by
multimeter, is it between AC 220-240
V?
Check if export voltage from PCB to
electromagnetic valve, is it between
AC 220-240 V?
Readjust or replace the broken parts
Open the tap or wait for normal water
pressure to use
Clean the inlet value
Open the tap or wait for normal water
pressure to use drain pipe not reach
80. Observe if the height of em. If
water level the hose is leaking gas
Electromagnetic valve must be
broken, please replace it.
The wire connected PCB and inlet
valve is notproperly. Please
reconnect it or replace it.
Cut off power, and check if motor
wire is connected well
Connect them well and test.
Check if the wire of motor is
connected wellwith computer board.
Connect them properly and test.
Summary of Contents for HW60-1081
Page 21: ...Print In China ...
