Haier HW60-1279, User Manual

6 

In

on 

Adjus ng the b

om cover

Before removing the transpo

on bolts, please fix 

the bo om cover to the bo om of the washing 

machine. Lay down the machine (fig.1), unscrew the 

feet and fit the bo om cover with the four holes 

corresponding to the screw holes of the feet. Then 

screw the feet back on through the cover and fix it 

thus securely to the bo om of the machine (fig 2.). 

It keeps out the dampness and reduces the noise. 

Dismantle the transport

on bolts

The transpo

on bolts are designed for clamping an -

vib

on components inside of the washing machine during 

the transpo

on process. 

Remove the back cover. 

Remove the four bolts on the rear side and take out 

the syn

c stabilizers from within the machine. 

Replace the back cover. 

Fill the holes le  by the bolts with blanking plugs. 

Note: 

When you replace the back cover, the convex

must face to outside, and you have to insert the 

back cover from the two gaps as shown in fig.5. 

Keep the transporta on bolts and synthe c 

stabilizers in a safe place for later use. 

Adjus ng the feet

There are adjustable feet under the bo om of the washing machine. Before 

use, they should be adjusted so that the machine is level. This will minimize 

vibr

ons and thus noise during use. It will also reduce wear and tear. We 

recommend using a spirit level to level the appliance. The floor should be as 

stable and flat as possible.  

Before Use

5.