Error message:The required water level is not reached within 8 min, or the water level exceeds the
protection value
Troubleshooting:
N
Check if inlet valve is jammed
Clean inlet valve
N
Draw out the dispenser and check if water is
entering
Observe if the height of
drain pipe not reach 80
cm. If water
the hose is leaking gas
N
Turn on power, and set pre-wash mode, then
start.
Check
the
import
voltage
of
electromagnetic valve by multimeter
, is it between AC 1 2 0 V?
Electromagnetic valve must be broken, please replace
it.
N
Check if tap is closed or water pressure is too
low (usual between 0.05-1MPa)
Open the tap or wait for normal water pressure to use
The wire connected
and inlet
valve is not properly. Please reconnect it or replace it.
Y
Y
Y
Y
Y
Check if water is leaking from washer
bottom. inlet pipe. drain pipe or other
pipe connection
Y
Readjust or replace the broken parts
Replace display board
N
N
Check if export voltage from
to electromagnetic valve, is it
between AC 1 2 0 V ?
and
level sensor
board
display baord
SERVICE MANUL
HWD-D1200TXVE-S
Washing
Machine
Summary of Contents for HWD-D1000TXVEME
