NOTE:
This washer is to be connected to the water mains using new hoses. Old hoses
should not be used. Do not install your washing machine in a room where
temperatures may be below freezing.
Frozen hoses may burst under pressure.
If the washer is delivered in the winter
months and temperatures are below
freezing, store the washing machine at
room temperature for a few hours before
putting it into operation.
Drain System
t5PQSFWFOUXBUFSMFBLBHFEPOPUQMBDFUIFESBJOIPTF
higher than 96 inches from the bottom of the washer and
secure drain hose tightly.
Using the provided clamp connect the drain hose to the
washer.
NOTE:
1) Drain hose, clamp, drain hose holder and tie
strap are placed in the accessory bag in the
drum.
2)
Use tie strap to secure the drain hose to a stand
pipe, inlet hose or laundry tub.
3)
Care should be taken so the drain hose
is not immersed in water.
Level the Washer
t-FWFMJOHUIFXBTIJOHNBDIJOFQSPQFSMZQSFWFOUTFYDFTTJWF
noise and vibration. Install your washer on a solid and
level floor surface.
t*GUIFGMPPSJTVOFWFOBEKVTUUIFBEKVTUBCMFMFHTBTSFRVJSFE
The legs can be extended to level the washer. The more the
legs are extended, the more the washer will vibrate.
t6TFBMFWFMUPNBLFTVSFUIBUUIFXBTIFSJTQFSGFDUMZMFWFM
t-FWFMJOHPGZPVSXBTIFSNVTUCFEPOFXIJMFUIFXBTIFSJT
spinning with a load. Use a wrench to adjust the legs until
there is no vibration. Once done tighten the lock nuts to
level the washer.
NOTE:
Do not lift the washer using the dispenser drawer or door as a handle.
Steps to Level the washer (As shown in the figure)
1. Loosen the lock nut using a wrench.
2. Level the washer by turning the adjustable legs.
3. Turn the lock nut on each leg towards the base of the washer
with
a wrench.
4. Once leveled tighten lock nut against the housing.
11
lock nut
leg
English
COLD HOT
30
min.
(76cm)
96
max.
(244cm)
figure 4
