6
Install the water inlet hose
Water tap,suitable
Water tap,not suitable
It is required that the front end shall be longer than 10mm.
The outlet end surface of the tap shall be flat and smooth. If not please file it to
avoid leakage.
3.Loosen the screw till the water tap can be accessed. Put the jointer of the water
inlet hose on the tap. See to Figure 2. (If the tap diameter is too large and the jointer
can not be set on the water tap, please loosen the four screws and take out the
bushing in the jointer. See to the figure3.)
2.Press the lower end of the lock lever and push down the slider. Take off the water
inlet hose jointer from the water inlet hose component. See to Figure 1.
Remarks: Before twisting the fastening nut, the thread is 4mm above the
upper surface of the nut. After twisting the fastening nut, the thread is 2mm
above the upper surface of the nut. See to Figure 6.
5.Take off the nameplate. Twist the fastening nut as per the indication of the figure.
See to Figure 5.
4.Fasten the four screws evenly. See to Figure 4.
>10mm
Outlet end surface
Nut
About 4mm before twisting
About below 2mm after twisting
Screw
Screwdriver
Mark label
bushing
Figure 2
Figure 5
Figure 1
Figure 4
Figure 3
Figure 6
Slider
Water inlet pipe jointer
Water inlet pipe
Locking lever
Confirm the water tap
Connection between the water inlet hose jointer and
the water tap
1.Use the new water inlet hose provided with the machine to connect to the water
faucet.Old hose sets should not be reused.
11
Use the operation buttons
b. Operating procedure and explanations for the
buttons
POWER
ON/OFF
START
PAUSE
PROGRAM RESERVE
WATER
LEVEL
SOAK
WASH
RINSE
SPIN
INDICATION OF PROCESS
(NO CHOOSING)
PROGRAM
HEAVY
SOFT
SAVE
SINGLE WASH
TUB CLEAN
STANDARD
After switching on, the "Standard" program will be the default. If other full-automatic program is
desired, you can press the button "
" to get the corresponding
indicator on. Refer to the "Button of '
'"
paragraph on page 10.
Example: Use the "Save" program for slightly soiled articles.
PROGRAM/RESERVE
PROGRAM/RESERVE
When "standard" program is selected, the washing
machine will perform full-automatically controlled fuzzy
program to set water level, water flow and wash duration
according to the cloth nature and weight
Page 10
1 Press the "POWER ON/OFF" button to switch on
the power supply
2 Press the button of"
" to select
a suitable full-automatic program
PROGRAM/RESERVE
POWER
ON/OFF
PROGRAM
RESERVE
The appliance is to be connected to the water mains using new hose-set
and old hose-set should not be reused.
Summary of Contents for HWM6802
Page 7: ......
